28
5.1.2 CONFIGURING THE ENGINE FOR NARROW USE
Connect disk drives to external SCSI buss port.
Power on the disk drives and Engine
When the BIOS screen appears PRESS THE SPACE BAR, before the -
“Press Key To Display Boot Menu” Countdown ends.
Under Booting Procedure press RC and press Enter .
A message should appear next on screen asking
“Do you want to use the recommendedNVRAM Configuration” PRESS N
Press C then Enter - to “Reconfigure The System Setup”
Press Return untill the cursor has moved down to the 11 th line -
Slot 1 SCSI Wide........
At this point you will need to know which PCI slot the SCSI Controller Card has been fitted
in. Looking at the Merlin Engine from the rear will show which slot the card is in -
Slot 1 is the top most slot
Slot 2 is the middle slot
Slot 3 is the Bottom slot
Use the Enter key on the Console Keyboard to move down the list to the correct
slot.
Next press 0 on the Console Keyboard to change from Wide to Narrow use.
Then Press Enter untill the following message appears on screen
“Enter the NVRAM Section you wish to Update”
Select Q and then press Enter.
A message will appear -
“NVRAM Configuration is complete ....System will now restart”
Press Return on the Console Keyboard.
The configuration is now complete.
To Next Page
Loading...