24
7.13.3 If the switch is faulty remove by undoing two fixing screws on mounting plate.
7.13.4 Apply heat sink paste to underside of thermostat plate and re-attach new thermostat
to mounting plate.
7.13.5 Electrical connections to be restored as per detailed in wiring diagram.
7.14 OVEN SAFETY TRIP SWITCH REPLACEMENT (FRONT ACCESS)
7.14.1 In any condition where space is restricted at appliance rear, the overheat safety trip
may be accessed through the oven compartment by removal of pan support panel.
7.14.2 Undo top and bottom fixings of fan baffle and tilt baffle forward to remove.
7.14.3 Take care not to strain the electrical wiring.
7.15 OVEN LIGHT BULB REPLACEMENT
7.15.1 Undo lens cover fixings.
7.15.2 Undo bulb and replace
7.15.3 Refit lens cover and ensure seal is not damaged.
7.16 OVEN LAMP ASSEMBLY REPLACEMENT
7.16.1 Remove control panel as detailed in Section 7.1
7.16.2 Remove right or left hand door (as required) by undoing door hinge fixings. Support
door during this process.
7.16.3 Remove fixings from side panel front.
7.16.4 Remove fixings from side panel rear.
7.16.5 Disconnect electrical connections.
7.16.6 Remove lamp assembly
7.16.7 Replace in reverse order.
To Next Page
Loading...
Need help?
General
