Fancom 743 - 6. Alarm; 6.1 Switching the alarm OFF

Fancom 743 6. Alarm
40
6. Alarm
6.1 Switching the alarm OFF
The alarm key will flash during an alarm situation ( ).
Press this key to view the type of alarm and in which storage silo the alarm situation is present.
Alarm value 10 indicates that there is an alarm situation. The current alarm can be switched off
by setting the alarm value to 0 or by pressing 2×. The following text will appear on the
display:
The following alarm values can be entered or read out at alarm key :
Table 1: Overview alarm values
Value
ValueValue
Value Situation
SituationSituation
Situation Explanation
ExplanationExplanation
Explanation
0 Alarm stand by There is no alarm.
1 Alarm test
Set alarm to 1 to test it; then reset alarm to stand-by by entering the
value 0.
5
Alarm
cancelled
There was an alarm which has been cancelled. The computer
switches off the alarm, but the alarm code remains visible.
6 Silent alarm Alarm message shown on display only.
7
Alarm
temporarily off
Set value to 7 to temporarily switch off the current alarm. When the
alarm situation has been cancelled, this value will automatically
become 0 again. Always check that the value has reverted to 0.
8, 9
Alarm
blocked
Set the value to 8 or 9 to switch off the alarm entirely. Only do this
when houses are unoccupied. Do not forget to reset value to 0.
10 Alarm The type of alarm is shown on the display.
Alarm 10
Feed dosing alarm 2
Alarm stand by 0