Fanimation AIRE DROP Studio LP8068LMW - Page 14

14
How to Assemble Your Light Kit (Continued)
Light Kit
Light Kit
Light Kit
Glass
Motor
Assembly
LED Assembly
LED Assembly
3. Remove the three screws in the light kit and retain
the screws for later. (Figure 3)
4. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 4)
Figure 4
5. Assemble the LED assembly to the light kit using
the removed screws from Step 3 and secure all three
screws. (Figure 5)
Figure 5
6. Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually until it
snaps onto the light kit. Do not over-tighten.
(Figure 6)
Figure 3
Figure 6
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.