9
3. Route the black, white and blue wires through the
downrod. (Figure 3)
4. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten
the two previously removed set screws with locking
nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Black, White and
Blue wires
Downrod
Downrod
Set Screws and
Locking Nuts (2)
Hairpin Clip
Clevis Pin
Figure 3
Figure 4
How to Assemble Your Ceiling Fan (Continued)
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white and blue wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Ceiling Canopy
Canopy Screw
Cover
Motor Coupling
Cover
Figure 5
Figure 6
6 to 9 in.
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Figure 7
To Next Page
Loading...
