12V 23A
Battery (1 pcs)
Figure 3
Figure 4
Dip Switch
ON DIP
1 2 3 4 5
Remote
14
How to Operate Your Ceiling Fan (continued)
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitte
4. To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
firmly up or down. (Figure 4)
r, with fan
power off, then follow the remote code setting
process. (If not used for long periods of time, remove
battery to prevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
Figure 5
5. Remote functions: (Figure 5)
Uplight button: Turns light on and off.
Downlight button: Turns light on and off.
To Next Page
Loading...
Need help?
General
