Faraone ELEVAH 40 MOVE PICKING - Page 44

USE AND MAINTENANCE MANUAL - SECTION 4
STOCK PICKER ELEVAH 40 MOVE PICKING / B PICKING - Rev. 14_2021
Page 4-23
The Supervisor Menu gives access to the following functions:
• Changing Supervisor PIN;
• Add / eliminate users;
• Last User;
• Maintenance cycle menu.
The User Menu gives access to the vehicle along with the option of carrying out the following
functions:
• Changing user PIN;
• Using the machine.
SUPERVISOR MENU
Access to the Supervisor Menu:
1. Press “00” to open the Supervisor Menu;
2. Enter the Supervisor’s code (4-8 digits);
3. Press “Power/Enter”
Ø The high-pitched beep accompanied by green and red LEDs indicate that the Supervisor Menu
has been accessed correctly
NOTE: Incorrect code entry is indicated by the red LED and a low-pitched acoustic sound.
NOTE 1: The default Supervisor PIN is factory set at (00) 1234. It is advisable to change this code following
the instructions below in “Function 1”.
NOTE 2: If the Supervisor PIN is lost or forgotten, the unit can be reset to the default PIN (00) 1234 by
simultaneously pressing 1, 3, 7 and 9 until the reset beep sounds, followed by the green and red LEDs flashing
4 times (after about 5 seconds). Press CE to confirm.
NOTE 3: Key activation is always confirmed when any key is pressed with a beep and the green LED flashing.
Once the Supervisor Menu is opened (as described above), the four permitted functions are now
available:
1. Changing the Supervisor PIN
2. Add / Eliminate users
3. Last User
4. Maintenance menu
Function 1 - Changing Supervisor PIN:
1. From the Supervisor Menu, press “1” and then press the “Power/Enter” key to access the
changing Supervisor PIN function;
Ø The high-pitched beep and single flashing of the red LED indicate that function 1 has been
accessed correctly.
2. Enter a 4 - 8 digit PIN and then press the “Power/Enter” key;
Ø The green LED will flash as many times as the number of digits entered (4-digit PIN = 4 flashes).
3. To confirm, enter the 4 - 8 digit PIN entered before and then press the “Power/Enter” key;
Ø The high-pitched beep accompanied by the green and red LEDs lighting up indicate that the new
PIN has been accepted.
4. Press the “CE” key to save the new Supervisor PIN.
Ø The high-pitched beep accompanied by the green and red LEDs lighting up indicate that the new
PIN has been saved, you are then taken back to the Supervisor Menu.
5. Choose another function from the Supervisor Menu or press “CE” to exit the Supervisor
Menu.