USE AND MAINTENANCE MANUAL - SECTION 4
STOCK PICKER ELEVAH 40 MOVE PICKING / B PICKING - Rev. 14_2021
Function 2 - Add / Eliminate users
1. From the Supervisor Menu, press “2” and then press the “Power/Enter” key to access the
Add / Eliminate user function.
Ø The high-pitched beep and two flashes of the red LED indicate that function 2 has been accessed
correctly.
2. Press the 2-digit user ID (01-99) to be enabled and then press the “Power/Enter” key.
Ø The unit will respond with the green LED and high-pitched beep to indicate that the user ID is
available or the red LED and low-pitched beep to indicate that the user ID is already assigned.
3. Press the “Power/Enter” key again to edit the user ID status. One of the two following results
will occur:
• The green LED / high-pitched beep ⇒"indicates that the user ID is enabled.
• The red LED / high-pitched beep ⇒"indicates that the user ID is disabled.
NOTE: During the above procedure the status of the user ID can be switched from disabled to enabled mode
by pressing the “Power/Enter” key again.
4. Press the CE key to save the assigned user;
Ø The high-pitched beep accompanied by the green and red LEDs indicate that the assigned users
have been changed correctly.
5. Repeat the process to add / eliminate other users or press the CE key to exit the Supervisor
Menu.
Function 3 - Last User
1. From the Supervisor Menu, press “3” and then press the “Power/Enter” key to access the
Last User function;
Ø The high-pitched beep and three flashes of the red LED indicate that function 3 has been accessed
correctly.
2. Press the “Power/Enter” key to start reading the user code;
NOTE: the code is given as a combination of flashes from the indicator LEDs. The green LED indicates the
tens digit and the red LED indicates the units digits.
(Example: 8 flashes of the green LED followed by 3 flashes of the red LED indicate that user n°83 was the last
person to use the machine.)
3. To display the Last User again, press the “Power/Enter” key again;
4. Press CE to exit function 3;
Ø The high-pitched beep accompanied by the green and red LEDs indicates exit from function 3.
5. Choose another function from the Supervisor Menu or press “CE” to exit the Supervisor
Menu.
To Next Page
Loading...
