Fasep B112 - Measurement and Correction of Unbalance; Wheel Mounting and Preparation

Fasep 2000 srl Rev. 1.8
Balatron 222/212: User’s Manual 23 January 2020
5-1
5 MEASUREMENT AND CORRECTION OF UNBALANCE
5.1 Placing the wheel rim on the wheel balancer
5.1.1 Select the cone or flange suitable for the wheel to be balanced. Specific mounting instructions are delivered with each
flange.
 NOTE The operation of centering and tightening of the wheel on the flanges is of basic importance for correct
balancing. Good results depend on proper performance of these procedures.
Clean accurately all cones, shaft and adapter surface before placing the wheel on the wheel balancer.
! CAUTION Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked on
the flange being used.
5.2 How to compensate unbalance of flanges using AFC function (optional for B212)
 NOTE This operation allows to put compensate unbalance of flange and other accessories.
5.2.1 Lock the required flange on the shaft without the wheel.
HOW TO TURN ON AFC FUNCTION HOW TO TURN OFF AFC FUNCTION
The AFC led blinking.
The AFC led is on.
Remove the flange.
The AFC led switch off.