8
FAVERO Electronics - 0259-0902A Assioma user manual _Rev12 - EN-IT-DE
ENGLISH
Important warnings to avoid communication problems during the pairing:
• Make sure that there are no other power meters switched on nearby
(10 meters).
• The bike computer must be within 2 m from Assioma.
10.2. Conguration of power elds
Once the pairing procedure has been completed (Chap. 10.1), it is possible to congure
the bike computer so that it displays the power data in the preferred way: please refer
to the bike computer manual.
It is recommended to at least set the following parameters: 3 second power, 30 second
power, cadence, 30 second average balance.
10.3. Crank-arm length
The crank-arm length affects power calculation: Assioma must know this length. An
incorrect value will lead to incorrect power values.
Please refer to the bike computer manual to learn how to set the crank-arm length.
If the crank-arm length cannot be set on the bike computer, set this parameter using
the Favero Assioma App.
Do not set the crank-arm length via the Favero Assioma App if the bike computer
already allows this operation; the set value would be overwritten.
11. Manual zero offset
Each Assioma sensor is factory calibrated to ensure its guaranteed precision under any
operating conditions, including ambient temperature variations, for which automatic
compensation from -10°C to +60°C is active.
No return to the Manufacturer is therefore necessary for periodic calibration.
However, it is important to periodically perform a “manual zero offset” on your bike
computer or app; to eliminate any measurement variations which may have occurred
over time, due to mechanical adjustments or impacts.
The zero offset function takes a few seconds and is often specied in the bike
computer with the term “calibration”.
Perform a manual zero offset adjustment any time the pedals are reinstalled.
For maximum precision, repeat the operation before every use.
To Next Page
Loading...
Need help?
General
