4
FAVERO Electronics - 0259-0902A Assioma user manual _Rev12 - EN-IT-DE
ENGLISH
7. Activating Assioma
Assioma must be activated to measure the power and cadence. If it is not activated,
such measuring will not be performed. The activation also determines the start of the
warranty period, allows updating the software and sending diagnostic reports to
check the correct operation of the product.
Activation is obtained with the specic “Favero Assioma
” app, available both for iOS
and Android. The app can be downloaded free of charge.
Make sure that your smartphone is compatible with the Bluetooth v4.0
standard or later versions, and that your internet connections is active.
Open the app and follow the instructions to perform the search, the connection to your
device and the activation. If Assioma does not appear in the search section, make sure
that it is not already connected via Bluetooth to another device (e.g. bike computer).
For more information, read the FAQs on the website: cycling.favero.com.
8. Fixing the pedals to the crank-arms
8.1. Washer use
The washers supplied are only necessary in the following cases:
• The crank-arm producer requires the use of a washer.
• The crank-arm has a recessed seat and one or two washers must be used to ensure a
free space between sensor and crank-arm.
Pressing the sensor against the crank-arm when tightening the pedal may damage
it. This operation would invalidate the warranty. If necessary, use 1 or 2 washers
to ensure a free space of at least 1 mm between the sensor and crank-arm.
If a cadence sensor is tted near the pedal, remove it to avoid any contact with the Assioma sensor.
≥ 1 mm
Crank-arm
with recessed seat
0 mm
To Next Page
Loading...
Need help?
General
