9
FAVERO Electronics - 0259-0902A Assioma user manual _Rev12 - EN-IT-DE
ENGLISH
How to perform a manual zero offset:
• Switch on Assioma.
• Turn on the bike computer or start an app. If Assioma is not detected, make sure it is
not already connected via Bluetooth to another device.
• Release the shoes from the pedals and make sure that they are not in contact with
anything.
• Place the crank-arms in the vertical position.
• Read the bike computer manual to learn how to:
• Open the power sensor menu.
• Press the “Calibration” or “Zero Offset” button.
• Make sure that the zero offset adjustment was successful; usually the
display shows a conrmation message or a 0 (zero).
• Repeat the operation if an error occurs.
Sometimes the zero offset is slowed down or prevented if other ANT+ sensors
(e.g. cardio band, cadence sensor) are enabled but switched off on the bike
computer, as the bike computer searches them but cannot nd them. In this case,
it is necessary to switch them on, or disable them temporarily on the bike
computer.
12. Using Assioma for the rst time on road or rollers
On the rst installation, Assioma will not send any power data to the bike computer
until it has completed the internal self-calibration. Assioma self-calibrates while
cycling by making a few tens of complete pedal strokes. To speed up the procedure, it
is advisable to cycle seated, at a uniform pace and on a leveled road. Self-calibration
can be considered completed once Assioma sends the power data to the bike
computer.
13. Battery charge
Assioma has an internal rechargeable lithium battery, with an approximately 50
hour life span. The capacity of each battery is tested during the manufacturing
process.
The battery life is very long thanks to the low number of battery charges required.
If you use Assioma for 15 hours a week, it is sufcient to charge it once every 3 weeks.
The battery can also be charged when it is only partially discharged: this will further
increase its life span.
If the product is not used for long periods of time, charge the battery anyway at
least every 3 months in order to avoid the risk of irretrievably damaging the
product.
To Next Page
Loading...
Need help?
General
