10
FAVERO Electronics - 0259-0902A Assioma user manual _Rev12 - EN-IT-DE
ENGLISH
When the battery of a pedal runs low, the bike computer will display a warning. The
remaining battery life, after a low battery warning, will be of about 8 hours.
To charge the batteries, follow the procedure below for each sensor:
• Connect the battery charger supplied to an electrical socket.
• Connect the USB cable supplied to the battery charger.
• Insert the micro USB connector into the magnetic connector (see the picture).
• If the sensor contacts are wet or dirty, dry or clean them with a dry cloth.
• Connect the magnetic connector to the pedal as indicated in the picture: the LEDs
switch on and remain switched on during the entire recharging. Once recharging has
been completed, the LEDS will blink every 0.5 seconds.
Recharging a completely discharged battery takes about 6 hours.
Recharge at a temperature ranging between 5°C and 40°C. Beyond this range,
recharging is blocked to protect battery functionality.
If necessary, Assioma can also be charged with a common smartphone battery
charger, instead of using the one supplied.
When a socket for battery charger is not available, a common “power bank” can be used.
To charge two sensors at the same time, use a model with 2 USB ports. Some models are
not able to fully charge the battery as their minimum charge current is higher than 50 mA.
Micro USB connector
Magnetic charging
connector
To Next Page
Loading...
Need help?
General
