FBD 37 Series - Receiving and Unpacking Dispenser; Installation Requirements and Mounting

37X INSTALLATION & OPERATION MANUAL
372/373 MODEL
5
4. RECEIVING AND UNPACKING DISPENSER
4.1 Receiving
Each dispenser is tested and thoroughly inspected before shipment. At the time of shipment, the carrier accepts the
dispenser and any claim for damages must be made with the carrier. Upon receiving the dispenser from the delivering
carrier, carefully inspect carton for visible indication of damage. If damage is present, have carrier note same on bill of
lading and file a claim with the carrier.
4.2 Unpacking
A. Cut banding from shipping carton and remove carton by lifting up. Remove protective side panels and four
corner protectors.
B. Remove drip tray assembly and accessory kit from top packaging. Contact the dealer if any parts are
missing or damaged.
C. Remove side panels from dispenser.
D. Inspect dispenser for concealed damage. If evident, immediately notify delivering carrier and file a claim
against same.
E. Lift dispenser up by the frame cross bracing and remove lower portion of carton.
F. If dispenser is received with a shipping board attached to the bottom, remove shipping board from bottom
of dispenser by accessing and removing the bolts located on the under side of the shipping board.
5. INSTALLATION
5.1 General Location Requirements
Dispenser is intended for indoor use only. A flat, level location is required for proper installation. When using a counter,
ensure it will support the weight of the dispenser plus the weight of any equipment placed near it. See the specifications
section for equipment weights.
Note: Maximum installation angle for surface placement should not exceed 8
O
for proper operation of dispenser.
Adequate space above and behind the dispenser is required to allow:
1. Removal of side panels, if service is necessary.
2. Air circulation around vents on sides, back, and top of dispenser.
A well-ventilated room is required for the dispenser. The environment, however, should be stable and not subject to abrupt
changes in temperature. The dispenser should not be exposed to direct sunlight or chemicals.