Page 17 of 35
5.1.4 Level 3
Access allowed only to the installer. All functions are accessible in this level and it is possible
whichever modification to change every setting: to restore the default configuration, to start the
test function, to set alarm or pre-alarm of the zones and to delay the siren outputs.
Procedure:
• Push <LEVEL> button (the led flashes fast).
• Insert the password of level 3 (default 333).
The led <LEVEL> is on and it flashes slow.
To abort the procedure, push <LEVEL> button.
Procedure to modify the password of level 3:
• Push <LEVEL> button (the led flashes fast).
• Insert the password of level 3.
• Push <LEVEL> button within 2 seconds (the leds <TEST>, <OUT OF SERVICE> and
<SIREN> flash fast).
• Insert the new password of level 3.
• Reinsert the new password of level 3 (a double beep gives the password change; a long
beep gives a change error).
It is not possible to have the password of level 2 equal to level 2.
To abort the procedure, push <LEVEL> button.
To Next Page
Loading...
