Page 6 of 35
3.1 ABOUT SAFETY
The control panel installation must be performed by qualified staff. Only authorized personnel
are designated to open the control panel; inside it is possible to find some parts with tension.
Product installation location.
Install the product in a dry place to protect it from atmospheric agents. Allow plenty of space
around the product to ensure ventilation. Do Not install the product across or near any heat
sources or in dirty place or exposing it to corrosive substances .
Excessive heat and/or heating devices can compromise the working and the product integrity.
Ensure a proper ventilation for the product.
Humidity or presence of condensation drops can damage the product. If there is condensation,
make sure to wait for the product to dry. If the product has been conserved in cold place for a
long time, it is necessary locate it in the installation place and wait two hours before connecting
it to the 230Vac net line.
WARNING: Only authorized personnel are designated to open the control panel. DO NOT try
to repair the product or else the warranty is not valid. Disconnect the power main and the
batteries before performing the maintenance on the product.
PART 3
CONTROL PANEL INSTALLATION
To Next Page
Loading...
