Page 26 of 35
To interrupt the procedure and return to level 1 without having applied any changes, press the
<LEVEL> button.
NOTE: the output delay is ignored if more than one detector goes into alarm, or if an alarm
button has been pressed (or a device where it is been installed a an alarm resistor).
If the user wants enable the delay at device with output relay, it is necessary to use a pre-
alarm resistor.
For this resistor values see chapter PART 9.
Two relay outputs are not delay.
To reset the delay time elapsed in alarm phase, it is necessary to press the <SIREN> button at
level 2.
To Next Page
Loading...
