3.11.4 Ethernet-Interface on X1 (10/100 Base-T)
The Reader has an integrated 10 / 100 Base-T network port for an RJ-45. Connection is made on
X1 and has an automatic “Crossover Detection” according to the 1000 Base-T Standard.
With structured cabling CAT 5 cables should be used. This ensures a reliable operation at 10 Mbps
or 100 Mbps.
The prerequisite for using TCP/IP protocol is that each device has a unique address on the net-
work. All Readers have a factory set IP address.
Table 13 Standard factory configuration of the Ethernet connection
Note:
The Reader TCP/IP interface has a DHCP option.
It is recommended to use a shielded twisted pair STP CAT5 cable.
Figure 23: LAN interface for host communication
To Next Page
Loading...
Need help?
General
