FeiYu Tech a1000 - Tilting Axis Forward;Backward Balance

①
②
③
（2） Adjust the center of gravity position of the tilting axis forward and backward: With the camera in the
upright position with the lens pointing forward and the hand arm maintaining a level state as shown
in figure ①, let go and observe the state of rotation. Loosen the screw on the bottom of the clamping
plate and adjust the balance by sliding the quick-release clamp up and down.(Refer to figure ② ③）
* After adjustment, be sure to tighten the lock screw.
Camera forward Camera backward
Balanced
Thumb screw
Thumb screw
Slide the quick-release
clamp
up to adjust
Slide the
quick-release
clamp
down to adjust
15
L
L
T
T