16
! "!#
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
POWER - Switches the POWER ON or OFF to the Cyber-Twin.
IEC AC POWER LINE CONNECTOR - The power line cord must be
connected to a grounded AC receptacle in accordance with the volt-
age and frequency ratings as listed on the rear panel of the unit.
FOOTSWITCH - Connect the included four-button footswitch at this
jack using the MIDI type cable provided. The footswitch offers the
same recall function as the front panel QUICK ACCESS keys. The
assign function is disabled from the footswitch. Although it uses a
MIDI type cable, this is an analog device and should be connected
only to the FOOTSWITCH jack.
EXPRESSION PEDAL - Connect the OUT jack of any standard
expression pedal (optional) at this jack. An expression pedal can be
assigned to control one of the following parameters per preset:
*
GAIN
*
VOLUME
*
TREBLE
*
MIDDLE
*
BASS
*
PRESENCE
*
REVERB
*
MASTER VOLUME
*
any REVERB parameter
*
any EFFECT parameter.
Expression pedal assignment is saved as part of a preset. This offers
you the flexibility to change expression pedal assignment with each
preset change automatically.
Expression Pedal assignment is done from the AMP Edit Mode, (see
“
” on page 24 for details).
REVERB / EFFECTS BYPASS - Connect the included one button
ON/OFF toggling footswitch at this jack to enable remote switching of
one of the following:
1) Bypass Reverb and/or effects in any of 8 possible input/output
combinations. Saved as part of each preset. Access the REVERB/
FX BYPASS using the AMP Edit Mode, (see REVERB/FX
BYPASS on page 24).
2) Switch between rotor speeds while VIBRATONE is the active effect
and
the Vibro Fast/Slow value is selected for the Reverb/FX’s
Bypass parameter, (see “Vibratone” on page 38).
Fender P/N
099-4055-000 or
00-57122-000
To Next Page
Loading...
