Fender Cyber-Twin - Page 24


20
$%& '! . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
$ 01+
Three Modes have menus that you can edit. The AMP Edit and the FX Edit
keys activate Modes that enable you to set preset parameters. The
UTILITY Mode is for global system functions. These 3 Modes are
organized in menus starting on the pages listed below.
(1) AMP
Edit Mode page 21
(2) FX
Edit Mode page 27
(3) UTILITY
Mode page 44
Press a Mode key to ENTER
the corresponding Mode.
Each press increments the display screen forward, one parameter, in a
continuous loop.
Rotate the DATA WHEEL to EDIT
the parameter selected above.
Press the EXIT key to EXIT
a Mode and return to the PLAY Mode.
    
The stored settings of many parameters define each amp design preset.
You can edit the most needed parameters directly on the front panel in
PLAY Mode as well as other Modes. These are included in preset saves:
*
GAIN
*
VOLUME
*
TREBLE
*
MIDDLE
*
BASS
*
PRESENCE
*
REVERB
*
NOISE GATE
*
FX LEVEL
*
FX VALUE 1
*
FX VALUE 2
(The 3 FX parameters change dynamically with preset selection.)
DATA
Mode Keys
WHEEL
ENTER
Modes
EDIT parameters
EXIT Modes
{ }
X
X
Preset Parameters editable from
the PLAY Mode; (TRIM and
MASTER are excluded from preset
saves and offer global control).