. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
""
59
#6
First, the System Exclusive
Header is sent. The amp will wait 200ms to look for a hand shake. If no hand shake is received then the amp
will transmit the first data packet. The transmission continues until all the information has been sent. After the
last packet, the End of File message is sent. In order for hand shaking to work the Device ID must be set to the
same ID as the amp. The hand shake messages that the amp will respond to are:
Use the following System Exclusive messages to edit other Preset parameters.
Value Description Hand Shake ID Description
F0H Start of System Exclusive Message 7CH Wait
7EH Universal Message 7DH Cancel
nnH nn = Device ID (minus one) 7EH Not Acknowledge
hdH Hand Shake ID 7FH Acknowledge
ppH Packet Number
F7H End of System Exclusive Message
Parameter Edit ID Description
F0H Start of System Exclusive Message
08H Fender’s Manufacturer ID
nnH nn = Device ID (minus one)
11H
Amp ID number 11H. The upper nibble identifies the
Cyber-Twin and the lower nibble is the software version
05H Message ID number for additional parameter controls
ddH Parameter ID Number. (See list below)
vvH Value for the parameter you wish to edit (See list below)
7BH End of System Exclusive File Byte
F7H End of System Exclusive Message
Parameter ID
Parameter
ID Number (ddH) Value (HEX) (vvH)
Tone Stack Type 00H 00H = Tweed
01H = Blackface
02H = British
03H = Modern
Tone Stack Position 01H 00H = Pre-Distortion
01H = Post-Distortion
Drive Circuitry 02H 00H = Blackface Tube1
01H = Blackface Tube2
02H = Blackface Tube3
03H = Tweed Tube1
04H = Tweed Tube2
05H = Tweed Tube3
06H = Hot Rod Tube1
07H = Hot Rod Tube2
08H = Hot Rod Tube3
09H = HMB Tube1
0AH = HMB Tube2
To Next Page
Loading...
