1.3.1.19 Brake specificat
ions
Park brake system Manual control, mechanical actuation
Service brake system Actuated with the tractor brakes
Drum size 406 mm x 120 mm (16 in x 4.72 in)
1.3.1.20 Maximum speed
Tandem axles and brakes 60 kph (37 mph)
Do not exceed the maximum legal speeds for this machine on public roads.
1
.3.1.21 Tractor requirements
PTO horsepower, minimum
Packer 186 kW (250 hp)
Tractor weight, minimum
Tow the baler only 9072 kg (20000 lb)
Power tak
e-o (PTO)
PTO speed 1000 rpm
PTO type ISO (ASABE) Type 3, 45 mm (1-3/4 in), 20
tooth
Hydraulic cylinder power from the remote circuit
Pickup lift 1 double acting
Tandem axle 1 single acting
Electrical system
Power For stand alone terminal only: 12V DC, 3
pin cab plug with switched, unswitched,
and ground. ISO bus plug required for all
other terminals.
Lamps ISO or ASABE with 7 pin electrical
connector
1.3.1.22 Noise level
T
he level of airborne noise generated by this baler and measured at the baler’s outside surfaces is not
more than the following value:
Noise level 98 dB(A)
The noise level was determined with a baler that was in operation, but not under a load. The noise level
generated b
y this baler will vary with crop conditions and with dierent tractors.
1.3.2 Bolt torque values
All bolts used on this machine are metric unless specified. Alw
ays replace bolts and other hardware with
the specified hardware. Metric bolts show the grade on the head. SAE bolts have 2 lines less than the
grade. For example, if a bolt has two marks the bolt is an SAE grade 5. Use the tables to find the correct
torque. If the manual gives a dierent torque, use the torque in the monual.
GUID-CC3D5AC7-866B-4762-B1ED-F7D50B58B3E0 [V1]
GUID-2B596B5D-CE08-4AD2-B9B3-1AFB04B83D1C [V1]
GUID-C01DDD90-2F33-4CD0-8D5F-C32D81462DAB [V1]
GUID-5B807E6F-132F-48E2-BDE8-5C1289CCAA7A [V1]
GUID-6CE42D02-70EC-4277-AF7E-E51D824F44B5 [V1]
1. General
1-28 Large Square B
aler
79037317B
To Next Page
Loading...
Need help?
General
