FENDT 916 Vario - Lubrication Chart

255
TECHNICAL DATA
5. Lubrication chart
5.1 Filling points
Text-module
Engine:
turn dipstick (B) and
remove, fill with
engine oil (A).
Transmission:
Turn dipstick (A) and
remove, fill with
transmission oil.
Axle drives, each
side:
Pour in oil through
filler hole (B).
Front axle
differential gear:
Fill up to overflow at
filler hole (A).
Front axle hub
drives:
fill until the oil spills
over, with hole on
the left and marker
in horizontal
position.
Front PTO:
Fill up to overflow at
filler hole (A).
Lift shaft:
fill until oil is approx.
40 mm below filler
hole (A).
Hydraulic system:
Unscrew filter cover
(A). Fill with oil.
Brake and clutch
system:
Fill container
(arrowed) with
Pentosin CHF 11S.
Cooling system:
Pour clean, low-lime
water containing
anti-freeze into con-
tainer (arrowed).
Windshield washer
system:
Pour fluid into
container (A).
Compressed-air
system:
Fill antifreeze
container (B) with
ethyl alcohol.
Fuel tank:
fill with fuel through
filler neck (A).