90
OPERATION
20.3 Comfort version
Operating console, right side
Operation_Pic_number:1
O = Depth control
P = Quick lift key
Vario terminal
Operation_Pic_number:1
Symbols (A, B) appear when the power lift is
lifting or lowering.
● When key (F1) is pressed, the following EPC
front sub-menu appears.
DANGER:
Select 'Stop' to prevent undesired
movements of the power lift.
Floating position
EPC automatic
(also refer to OPERATION
Section 14.1).
Fig.200
Fig.201
Operation_Pic_number:1
Settings are adjusted by three rotary controls
(P1, P2, P3).
A 1 = Lift height limiter
A 2 = Position of the power lift
P3 = Rotary control lift height limit/position of
the power lift
B = Lowering speed
P2 = Rotary control for lowering speed
C = Lift speed
D = Power lift active
P3 = Rotary switch for lift speed
E = Power lift in floating position
F1 = Power lift lock ON/OFF
F2 = No function in this sub-menu
F3 = No function in this sub-menu
F4 = No function in this sub-menu
F5 = No function in this sub-menu
ESC = Return to higher-level menu
Text-module
EPC safety lock
When safety lock is active, the power lift does
not function.
ETNum-list
The safety lock becomes active in any of the
following situations:
1.When ignition is switched OFF/ON.
2.When starting the tractor.
3.When there is a fault in the electrical circuit.
4.After operating the front controls.
Fig.202
To Next Page
Loading...
