Page 16
Canceling Ringtones (do not disturb function)
If during call volume regulation the potentiometer is turned down to its
minimum level, a constant red led will light up to indicate that the call
has been disconnected, do not disturb function.
The disconnection option affects all ringtones generated by the tele-
phone:
To deactivate ringtone cancellation, you must move the potentiometer
above the minimum level. The led will return to its previous status.
Note:
- If disconnected, the call extension sounds or the lights and bell activator is
activated. Through this, the same tone is sounded as that confi gured for the
call answering tone from the panel, guard unit or doorbell.
- For more operating information: See See “Call Volume Regulation”.
LED
POTENTIOMETER
bip
Beep
Call to reception
This is done bypressing the
button when the telephone is in standby and hung-up. The
call to reception is made to the reception that is activated for the block in which the telephone
is, sounding a beep when the confi rmation is received from this reception.
If the block´s guard unit is not active (night mode) the call to a guard unit is made to the
general guard unit if there is one active. If the installation does not have an active guard
unit, the phone will not beep.
To Next Page
Loading...
