FESLEY FED-1000 - Playback Speed and Sensitivity; Factory Reset

13
Press and hold the "save. Reset" button for more than 3 seconds to reset all parameters and
restore factory settings. (Figure 6)
11
Reset factory settings
1. Press the "menu" button repeatedly until the display shows (utility), and enter the sub option
reverberation / equalization optimization mode. (Figure 10)
2. Use the "∨" key to select the following options as adjustment. (Figure 4)
THE DISPLAY SHOWS:
● (revtype 000-005): reverberation category, 6 kinds in total, adjustable.
● (revlevel 000-127): reverberation intensity level, 128 levels in total, adjustable. When the value
is "000", reverberation is turned off.
● (eq_h 000-127): high frequency equalization, 128 levels in total, adjustable.
Adjustable low frequency equalization (eu-000, l): 128 ●#.
3. Turn the "quick selection wheel" to adjust the parameters of the above options. (Figure 5)
4. Short press the "save. Reset" button to save the adjusted parameters for future use. (Figure 6)
9
Reverberation / equalization optimization
1. Press the "recording" button to enter the percussion recording mode, and tap the drum to
start recording. Press again to stop recording. (Figure 11)
2. Press the "playback" button to play the percussion song just recorded. Press again to stop
playback. (Figure 12)
10
Percussion recording
In the demonstration song or metronome playing mode, adjusting the speed can control the speed
of demonstration song and metronome playing.
1. Press the "menu" button repeatedly until the display shows (tempo), and enter the sub option p
layback speed mode. (Figure 10)
THE DISPLAY SHOWS:
● (speed 030-250): playback speed selection, 221 levels in total, speed adjustable.
2. Turn the "quick selection wheel" to adjust the parameters of the above options. (Figure 5)
7
Playback speed
1. Press the "menu" button repeatedly until the display shows (sensitivity), enter the sub option, and
enter the sub option percussion instrument component sensitivity adjustment mode. (Figure 10)
2. Tap the drum disc you want to adjust with a drum stick.
3. Use the "∨" key to select the following options as adjustment. (Figure 4)
THE DISPLAY SHOWS:
● (padsen 001-006): surface impact sensitivity, 6 levels in total, adjustable.
● (rimsen 001-006): side strike sensitivity, 6 levels in total, adjustable.
● (threhold 001-032): trigger threshold, 32 levels in total, adjustable.
● (xtalk 001-032): crosstalk threshold, 32 levels in total, adjustable.
● (retiger 001-032): repeated triggering, 32 levels in total, adjustable.
● (velocity 001-003): force curve, 3 levels in total, adjustable.
● (volume 000-127): drum volume, 128 levels in total, adjustable.
4. Turn the "quick selection wheel" to adjust the parameters of the above options. (Figure 5)
5. Short press the "save. Reset" button to save the adjusted parameters for future use. (Figure 6)
8
Drum sensitivity adjustment
OPERATION GUIDE