INSTALLATION GUIDE
Withdraw the nuts and circle cushions of arm the three cymbals' support arm, put the three
cymbals into the corresponding support arm, and screw on the nuts. Put 3 drums and 1
drum into the corresponding support rod respectively, and tighten the screws.
Note: the functions of each cymbal, drum and snare are different, so it is necessary to refer
to the accessory identification for correct installation!
10
Install striking parts and sound module
● Tighten the screws after the drum is inserted to avoid loosening.
● Don't screw the cymbale tightly, leave some space for them to shake up and down.
7
To Next Page
Loading...
