Need help?Do you have a question about the Festo CECC-X-M1-MV and is the answer not in the manual?
Essential safety guidelines and precautions for handling and operating the controller.
Describes the CODESYS V3.5 SP7 pbF software used for programming the controller.
Covers the setup and mapping of the controller's digital and analog I/O interfaces.
Guides on how to add and configure CANopen slaves within the CODESYS environment.
Guides on integrating and selecting IO-Link devices for the master port.
Covers setting up the controller as both a Modbus TCP client and server.
Explains how to configure the EtherNet/IP adapter and module for network communication.
Guides on adding and configuring EtherCAT masters and slaves.
Explains how to connect to the controller and manage applications in online mode.
Explains the meaning of the various status LEDs on the controller for error detection.
Essential safety guidelines and precautions for handling and operating the controller.
Describes the CODESYS V3.5 SP7 pbF software used for programming the controller.
Covers the setup and mapping of the controller's digital and analog I/O interfaces.
Guides on how to add and configure CANopen slaves within the CODESYS environment.
Guides on integrating and selecting IO-Link devices for the master port.
Covers setting up the controller as both a Modbus TCP client and server.
Explains how to configure the EtherNet/IP adapter and module for network communication.
Guides on adding and configuring EtherCAT masters and slaves.
Explains how to connect to the controller and manage applications in online mode.
Explains the meaning of the various status LEDs on the controller for error detection.
General| Input Voltage | 24 V DC |
|---|---|
| Number of outputs | 8 |
| Short circuit strength of outputs | Yes |
| Number of analogue inputs | 2 |
| Analogue input voltage range | 0 ... 10 V |
| Number of PWM outputs | 2 |
| PWM frequency | Up to 1 kHz |
| Degree of protection | IP20 |
| Protection class | III |
| Ambient temperature | -5 ... 50 °C |
| Operating temperature | -5 ... 50 °C |
| Type of mounting | DIN rail |
| Communication | Ethernet |
| Analogue input signal | Voltage |
| Storage temperature | -20 ... 70 °C |
To Next Page
