Need help?Do you have a question about the Festo CPX-CEC-S1-V3 and is the answer not in the manual?
General| Operating Voltage DC | 24 V DC |
|---|---|
| Operating Voltage AC | Not applicable |
| Number of Digital Inputs | 16 |
| Number of Digital Outputs | 16 |
| Protection Class | IP20 |
| Communication Protocol | EtherCAT |
| Operating Temperature | -5 to 50 °C |
| Number of Ports | 2 Ethernet ports |
Details warnings and cautions regarding dangerous movements and pressurised lines for safe operation.
Introduces the CODESYS V3 pbF software for configuring and programming the controller.
Details the procedure for physically mounting and removing the CPX-CEC-...-V3 device.
Explains how to configure the controller using its RUN/STOP rotary and DIL switches.
Provides safety warnings and notes for commissioning procedures.
Guides the user through initial steps of using the programming software.
Explains how to create a new project in the CODESYS environment.
Guides the user on selecting the correct CPX-CEC device within the project.
Explains how to automatically find connected devices on the network.
Explains how to establish a communication channel with the controller.
Covers scanning for devices and changing network settings.
Describes the utility for scanning and identifying Festo devices on the network.
Guides on modifying network properties like IP address for found devices.
Explains how to configure the CPX system and its modules using order codes or scanning.
Details configuring the system by inputting the product's order code.
Describes how to set parameters for the CPX terminal and its modules.
Details how to configure system-wide settings for the CPX terminal.
Explains how to parameterize individual CPX modules.
Details configuration for SoftMotion features for multi-axis control.
Explains how to configure Modbus TCP client and master functions.
Details setting up the controller as a Modbus TCP client or master.
Guides on configuring the controller as a Modbus TCP slave.
To Next Page