Need help?Do you have a question about the Festo CECC-X-M1 and is the answer not in the manual?
Outlines essential safety precautions for handling, installation, and operation.
Information on CODESYS V3.5 SP7 pbF for controller configuration and programming.
Guides through creating a new project and selecting the controller device in CODESYS.
Steps for setting up the controller as a Modbus TCP client or server.
Procedures for logging into the controller and managing application transfer.
Outlines essential safety precautions for handling, installation, and operation.
Information on CODESYS V3.5 SP7 pbF for controller configuration and programming.
Guides through creating a new project and selecting the controller device in CODESYS.
Steps for setting up the controller as a Modbus TCP client or server.
Procedures for logging into the controller and managing application transfer.
General| Category | Controller |
|---|---|
| Current consumption without load at 24 V DC | 150 mA |
| Max. current consumption with load at 24 V DC | 500 mA |
| Number of digital inputs | 8 |
| Number of digital outputs | 8 |
| Short-circuit strength of outputs | Yes |
| Number of analogue inputs | 2 |
| Number of PWM outputs | 2 |
| Protection class | IP20 |
| PLC function | Yes |
| Web server | Yes |
| Fieldbus interface | Ethernet |
| Current consumption | 500 mA |
| Analogue input signal | 0-10 V |
| Ambient temperature | 0 ... 50 °C |
| Programming | CODESYS |
| Communication | Modbus TCP |
| Operating temperature | 0 ... 50 °C |
| Storage temperature | -20 ... 70 °C |
To Next Page