Festo CMMP Series Brief Overview

Festo P.BE-K-CMMP-AS-C20 1010NH English 25
Main
index
Sub-
index
Error message
Cause/measure
15
x
Division by zero
Please contact Technical
Support.
16
x
Initialiszation fault
17
x
Drag error
Enlarge fault window,
reduce acceleration
21
x
Fault in offset current
measurement
Please contact Technical
Support.
22
x
Fault in PROFIBUS
Slave address, bus
termination and cabling
Please contact Technical
Support.
25
x
Invalid device type
Please contact Technical
Support.
26
x
Checksum fault
27
x
Warning threshold
drag error
Check parametrizing
28
x
Operating time
counter
Acknowledge fault. If fault
occurs again, contact
technical support.
30
x
Internal conversion
fault
Please contact Technical
Support.
31
x
I
2
t-fault
Mechanic part blocked,
check application.
32
x
Intermediate curcuit
Please contact Technical
Support.
33
x
Drag error in encoder
emulation
34
x
Synchronization fault
in field bus
No synchronization
messages from the master.
35
x
Protection against
slipping of linear
motor
Sensor signals are faulty.
Check the installation.
36
x
Parameter fault
Check user parameter
record.

Festo CMMP Series Specifications

General

Control Mode	Position, Torque
Communication Interfaces	CANopen, EtherCAT, PROFINET, Ethernet/IP
Power Supply	24 V DC
Feedback System	Incremental encoder, Absolute encoder
Number of axes	1
Relative humidity	5% to 95% (non-condensing)
Operating temperature	0 °C ... +50 °C