Festo CP-E16 Series - Page 34

Status LED Sequence Operating status Error treatment
LED lights up
Operating voltage applied None
LED is out
- Operating voltage not
applied or no connection
to higher-order system
or
In conjunction with CP node:
- incorrect string assignment
ascertained during
operation
In conjunction with SPC200:
- see user manual
for SPC200
• CP cable and
Check operating voltage
connection on higher-
order System
or
• Correct string
assignment
• See user manual
type P.BE-SPC200
LED flashes
- Test phase after voltage
is switched on
or
- short circuit in
sensor supply
or
In conjunction with CP node:
- incorrect string assignment
when voltage is switched on
In conjunction with the
SPC200:
- see user manual
for the SPC200
• None
or
• Eliminate short circuit
and delete error
1)
or
• Check string assignment
2)
• See user manual
type P.BE-SPC200
1) The error can be deleted if the input module is separated from the line or if the power
supply is switched on again at the higher-order system.
2) If the line assignment has been modified (CP modules added or removed), you must
store the new line assignment by pressing the SAVE button on the node
(see manual "CP system, installation and commissioning").
ON
OFF
ON
OFF
ON
OFF
1. Input module type CP-E16...-M...-...
CP-E16...-M... 9901b 1-23