Festo SBSi - Page 5

Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016 Page 5
Vision Sensor Manual
4.3.5 Result 47
4.3.6 Start sensor 48
4.4 Vision Sensor Visualisation Studio, display images and results 49
4.5 SBS – Operating- and configuration software – Vision Sensor Device Manager, all functions 50
4.5.1 Active sensors 50
4.5.2 Sensors for simulation mode 52
4.5.3 Find / Add active sensor 52
4.5.4 Configuring a connected sensor 53
4.5.5 Display images and result data 53
4.5.6 Sensor's network settings 53
4.5.7 Update / Firmware update 54
4.5.8 User administration / Passwords 54
4.6 SBS – Operating- and configuration software – Vision Sensor Configuration Studio, all functions 56
4.6.1 Jobs (Inspection tasks) 56
4.6.1.1 Creation, modification and administration of jobs 57
4.6.1.2 Loading and saving jobs and job sets 58
4.6.1.3 Parameters for image acquisition 59
4.6.1.4 Job, tab White balance 60
4.6.1.5 Preprocessing, Filter for image improvement. 61
4.6.1.6 Calibration 62
4.6.1.7 Parameters Cycle time 79
4.6.2 Alignment 80
4.6.2.1 Selection and configuration of an alignment detector 81
4.6.2.2 Alignment Pattern matching 82
4.6.2.3 Alignment Edge detector 84
4.6.2.4 Alignment Contour detection 86
4.6.3 Detectors 90
4.6.3.1 Creating and adjusting detectors 90
4.6.3.2 Selecting a suitable detector 92
4.6.3.3 Detector Pattern matching 92
4.6.3.4 Detector Contour 101
4.6.3.5 Contrast detector 109
4.6.3.6 Grey detector 113
4.6.3.7 Brightness detector 117
4.6.3.8 Detector BLOB, Introduction 120
4.6.3.9 Detector Caliper 133
4.6.3.10 Barcode detector. 136
4.6.3.11 2D Code detector 144
4.6.3.12 Detector OCR 152
4.6.3.13 Detector Color value 164
4.6.3.14 Detector Color area, Color select 166
4.6.3.15 Detector Color list 169
4.6.4 Output of inspection results 172
4.6.4.1 I/O mapping 172
4.6.4.2 Functions of the programmable, digital inputs: 175
4.6.4.3 Output signals (Digital outputs / Logic) 178
4.6.4.4 Interfaces 180
4.6.4.5 Timing, Digital outputs 184
4.6.4.6 Telegram, Data output 189