9. Extended functions of the parametrizing program
9−22
Festo P.BE−SEC−AC−SW−EN en 0802c
In the right−hand half of the oscilloscope window there are
four register cards for more exact settings:
for selecting and representing the channels
for setting the trigger
for setting the reversing generator
for setting the positioning module and the speed con
troller.
9.17.1 Register card Channel representation"
The oscilloscope possesses two channels. The following set
tings can be made in the register card:
1. The measured variable to be represented: Click the selec
tion box of the relevant channel.
2. The colour of the channel: Click the coloured box. A dia
logue for selecting the colour will be shown.
Scal 3. Y−scaling: Use the slide
switch next to Scal", in order to
set the enlargement in the vertical direction.
Offs 4. Offset / Y−position: Use the slide switch next to Offs", in
order to shift the ver tical position of the curve. A click on
the box resets the offset to 0".
Clear You can delete the representation of the two curves
by click
ing the Clear" button.
To Next Page
