Festo SPC11 Series Quick Reference

Festo SPC11 2018-12b English6
S The dimensions refer to the standard sizes of service
units, proportional directional control valves and
drives.
S If angled connectors cannot be avoided, use plug
connectors from the Quick Star series.
S Do not use any restrictors in the supply lines.
Drive and measuring system
S Use only the permitted combinations of valves, drives
and measuring systems approved of by Festo for the
SPC11.
S Observe the permitted fitting positions.
S Mount the measuring system symmetrical to the drive
stroke.
S Mount the drive, the guide and the measuring system
free of play and flush in the direction of movement.
Specially for drives type DGP(I)(L)-...-...-KF or DGP-... with
suitable guide):
S With bilateral air supply, open up completely the ad
justing screws for the internal end position cushioning.
S Use a measuring system with the same stroke length.

Festo SPC11 Series Specifications

General

Brand	Festo
Model	SPC11 Series
Category	Controller
Language	English