1 4 5
2 3
6968
4
Set the routing height: the distance from the flip stop to the
centre of the router should be half the worktop thickness.
With a worktop thickness of 38 mm, for example, set the
routing height to 20 mm.
Then set the routing depth to 50 mm and set the markers
to 50 mm and 30 mm.
Insert the 14 mm router.
Transfer the markings to the abutting surfaces of the worktop.
It is sufficient to do this where you later want to insert the flat
connectors.
2016_FES_DOMINO_Book_GB-en.indb 69 03.03.16 12:13
To Next Page
Loading...
