Festool DOMINO User Manual

8
7 11 12
96 10
7170
4
Then set a routing depth of 30 mm – this dimension depends on
the material. What is important to note is that the transverse
hole should overlap the longitudinal hole by 5 mm in depth. If
using the transverse anchors without enlarging clips, an overlap
of 3 mm suffices. The routing height should be set to 40 mm
– this setting is identical for each connector, because it is
based on the length of the connector. Route transverse holes
in both workpieces at the points where the flat connectors will
be inserted.
Switch the machine to the large hole width for the transverse
holes; this gives the transverse anchors enough space when
fitted with the enlarging clips.
Route the 50 mm deep holes with the narrow hole width
into both workpieces at the markings. The joining machine
is placed on the top side of the worktop in this case.
2016_FES_DOMINO_Book_GB-en.indb 70 03.03.16 12:13

Festool DOMINO Specifications

General

Motor Power	420 W
Dust Extraction Connection Diameter	27 mm
Power Source	Corded Electric
Cutting Depth	15 mm, 20 mm, 25 mm, 28 mm
Cutter Diameter	5 mm, 6 mm, 8 mm, 10 mm