FIBARO FGCD-001 - Page 13

13
ADVANCED PARAMETERS
Available settings: 0 - all actions disabled
1 - tampering (opened casing)
2 - exceeding the temperature
4 - lack of Z-Wave range
Default setting: 0 Parameter size: 1 [byte]
4. Acoustic signals
This parameter allows to set the actions which result in acoustic sig-
nals. This parameter does not apply to the most important actions,
such as CO Alarm, Malfunction Alarm and Low Battery Alarm.
Available settings: 0 - all actions disabled
1 - tampering (opened casing)
2 - exceeding the temperature
4 - lack of Z-Wave range
Default setting: 0 Parameter size: 1 [byte]
7. Associations in Z-Wave network security mode
Parameter denes how commands are sent in specied association
groups: as secure or non-secure. Parameter is active only in Z-Wave net-
work security mode. It does not apply to 1st “Lifeline” association group.
Available settings: 1 - 2nd group sent as secure
2 - 3rd group sent as secure
4 - 4th group sent as secure
8 - 5th group sent as secure
16 - 6th group sent as secure
32 - 7th group sent as secure
Default setting: 63 Parameter size: 1 [byte]
10. Commands sent to 2nd association group (CO Alarm)
This parameter denes commands sent to devices associated in 2nd
association group (CO Alarm). Values of specied commands may be
set in parameters 11 and 12.
Available settings: 1 - BASIC ON
2 - BASIC OFF
3 - BASIC ON & BASIC OFF
Default setting: 3 (ON & OFF) Parameter size: 1 [byte]
11. Value of BASIC ON command sent to 2nd association group
This parameter denes the value of BASIC ON command sent to de-
vices in 2nd association group after the CO Alarm activation.
Available settings: 0-99 or 255
Default setting: 255 (turn on) Parameter size: 2 [bytes]
NOTE
Parameter 3 values
may be combined, e.g.
1+2+4=7 means that
all actions will be ac-
tive.
i
NOTE
Parameter 4 values
may be combined, e.g.
1+2+4=7 means that
all actions will be ac-
tive.
i
NOTE
Parameter 7 values
may be combined,
e.g. 1+2=3 means that
2nd & 3rd group are
sent as secure.
i