3534
Chapter 8 Other Functions & Utilities
8.1 Data Storage
This splicer stores up to 10,000 splicing results. Contents of data stored are
dierent depending on splicing mode.
8.2 Display Splice Record
Splicing results stored in the splicer can be displayed.
Select Data Storage Menu and Select Display Splice Record to view.
8.3 Delete Splice Record
Splicing results can be cleared by part or whole.
① Select “Delete Splice Record”, and then input specic number (Start Splice
Record and End Splicer Record) of splicing results to be cleared.
② Select Delete Splice Record and press conrm key to conform. Selected
splicing results are cleared and replaced with following splicing results.
8.4 Cancel Data Storage
If you don’t want to store the records, press the "OFF" button in the "Splice Data
Save" Menu.
8.5 System Setting
This menu is used to change settings in detail, or for an administrator to limit
functions for operator to select or change.
7.9 Motor Drive
This function is used to test if 4 motors of the fusion splicer operate normally.
① Select “Motor drive”.
② Touch screen to select motor.
7.10 Update Software
① Select “update software” in “system setting”.
② Connect the USB driver with the copy of upgrade les to the USB port
③ Press “OK”, and then the splicer will process the update automatically. Upon
completion, the splicer will restart automatically.
③ Touch the icons of L press and R
press to drive motor, observing if the
motor can be driven normally.
To Next Page
Loading...