I
Operation Safety Rules
High optical power can cause bodily harm, especially to eyes.
Never look directly into the end of the optical transmitter fiber
jumper or the end of its active connector.
Exercise care if you must bend fibers. If bends are
necessary, the fiber bending radius should never be less than
38mm.
Power socket overload, broken cables or broken plugs may
cause electric shock or fire. Regular check-ups on power
supply wires and cables are essential. If any appear damaged,
replace at once.
Use the power supply adapter provided in the package only.
Using other adapters may cause equipment damage or
operation failures.
Install the equipment in a well ventilated environment without
high temperatures or direct sunlight to protect the equipment
and its components from overheating, which can result in
damage.
To Next Page
Loading...
Need help?
General
