FieldServer ProtoNode RER - Page 14

28 pages

Save Page as PDF

To Next Page

To Previous Page

Figure 15. Web Congurator showing a prole selected

Figure 16. Web Congurator showing a completed prole added

• Continue this process until all the Raypak VERSA IC Master units have been added.

APPROVED

UNCONTROLLED DOCUMENT IF PRINTED

Main Page

Table of Contents3
Introduction4
BTL Mark - Bacnet Testing Laboratory4
Lonmark Certification4
Interfacing the Protonode to Raypak Products5
Protonode RER (FPC-N34) and LER (FPC-N35) Showing Connection Ports5
Bacnet/Lonworks Setup for Protocessor Protonode Rer/Ler6
Installation Steps for the Customer6
Record Identification Data6
Configure Raypak VERSA IC Modbus COM Settings6
Select the Desired Field Protocol - for Protonode RER (FPC-N34)7
Using S0 - S3 Bank of DIP Switches7
Bacnet MS/TP, Bacnet/Ip, Modbus TCP, and Metasys N2 Settings for Protonode RER (FPC-N34)7
Setting the Device Instance (Node-ID) for Bacnet MS/TP and Bacnet/Ip on Protonode RER (FPC-N34)7
Setting the Node-ID for Metasys N2 and Modbus TCP on Protonode RER (FPC-N34)7
Setting the MAC Address for Bacnet MS/TP for the Protonode RER (FPC-N34)8
Set Field RS-485 Baud Rate for Bacnet MS/TP on Protonode RER (FPC-N34)8
Setting the Serial Baud Rate (DIP Switch B0 - B3) for Bacnet MS/TP8
Wiring Connections to Protonode RER (FPC-N34 Bacnet) and Protonode LER (FPC-N35 Lonworks)9
Connecting the VERSA IC Modbus Port to the Protonode's Phoenix 6 Pin Connector9
Wiring the Protonode RER to RS-485 Field Protocol (Bacnet MS/TP or Metasys N2)11
Wiring the Protonode LER (FPC-N35) Field Port to a Lonworks Network11
Power-Up the Protonode RER (FPC-N34 Bacnet) or Protonode LER (FPC-N35 Lonworks)12
Connect to the Protonode's Web Configurator to Setup the Raypak Products (Profiles) Connected to the Protonode Rer or Ler12
Connect the PC to the Protonode Via the Ethernet Port12
Configure Profiles in the Protonode's Web Configurator13
Selecting the Raypak Profiles that will be Connected the Protonode13
Changing Bn_Node_Offset Via the Protonode's Web Configurator15
Set IP Address for Bacnet/Ip Via GUI15
Commissioning the Protonode Ler on Alonworks Network16
Commissioning the Protonode LER on a Lonworks16
Network16
Instructions to Upload XIF File from the Protonode LER Using FS GUI Web Server16
Chipkin Automation's Cas Bacnet Explorer for Validating the Protonode in the Field17
Downloading Chipkin Automation's CAS Explorer and Requesting an Activation Key17
CAS Bacnet Setup18
CAS Bacnet MS/TP Setup18
CAS Bacnet Bacnet/Ip Setup18
Appendix A. Troubleshooting18
Check Wiring and Settings18
Take Diagnostic Capture with the Fieldserver Utilities18
Setting the Network Number for Bacnet IP20
LED Diagnostics for Modbus RTU Communications between the Protonode and Raypak VERSA IC20
Appendix B. Pics Statement21
Raypak VERSA IC Modbus RTU Mappings to Bacnet MS/TP, Bacnet/Ip, Metasys N2 and Lonworks21
Address DIP Switch Settings24
Appendix C. Reference26
Specifications26
Compliance with UL Regulations26
Limited 2 Year Warranty27

FieldServer ProtoNode RER - Page 14

Table of Contents

Related product manuals