12
! The AUTO-COMPENSATION FLOW CONTROL feature, which is standard on
the Filtrabox, will maintain the set-point “Airflow %” by automatically
increasing power to the blowers as the filters get obstructed by the dust. You
do not have to manually change the “Airflow %” setting again – unless you
change your laser or use a more fume generating substrate. Note: “Airflow
%” represents the Airflow potential of your system.
8. When the laser is not in use, press the “Power” button to turn the blower(s) off.
9. Filtrabox has an EZ-link feature that allows you to turn the blowers ON or OFF remotely from the
laser (if this feature is available on your laser). See the EZ-LINK section of the manual.
YOUR FILTRABOX LASER EXTRACTOR IS
NOW SET-UP FOR OPERATION.
To Next Page
Loading...