FILTRABOX COMPACTX - Filter Check; Select # of Blwrs; New Application Calibration; Service Menu

To Next Page

To Previous Page

FILTER CHECK SETTING

See the FILTER CHECK Feature in Filter Replacement Instructions.

NEW APPLICATION CALIBRATION SETTING

! This will initiate the Calibration sequence. Avoid doing this unnecessarily. This should only be

used if you are changing lasers, length of hose, diameter of hose; or anything that would change

(reduce or increase) the airflow restrictions in the entire system. Calibration should only be

done with a new set of filters otherwise the filter check feature will not function as intended.

While in the “New Application Calibration” setting, press the “OK” button to initiate

Calibration. The Calibration process will take approximately one minute.

SERVICE MENU SETTING

This menu is only to be used by Filtrabox Technicians or with the guidance of a Filtrabox

Technician.