26
AT THE END OF THE WORK
1. AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance:
1. Close the tap with lever (1) (versions without FSS)
2. raise the brush head by means of the pedal (2)
3. raise the squeegee by means of the lever (3)
4. Turn the key switch (4) to the O position to switch off the suction motor
5. Turn the key switch to the “1” position
6. bring the machine to the place provided for draining the water
7. Turn the key switch to the “0” position
8. Engage the parking brake
9. Remove the drainage hose from its compartment, unscrew the drainage cap and empty the recovery
tank.
10. The squeegee must be raised when the machine is not operating in order to avoid deforming the
rubber blades.
11. The brush head must be raised when the machine is not operating in order to avoid deforming to the
brush.
12. Disassemble the brushes and clean them with a jet of water (to disassemble the brushes, see the
related paragraph)
WARNING: this operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
2. EMPTYING THE MX HOPPER
Empty the hopper after work and before performing any type of maintenance, to do so proceed as follows:
1. Push the knob (1) towards the rear of the machine and release the left side splash guard.
2. Extract the hopper, empty and clean it thoroughly
3. reassemble all the elements.
4. Raise the brushing unit at the end of the work, to avoid deforming the brushes.
WARNING: this operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
1
2
3
4
1
To Next Page
Loading...
