27
AT THE END OF THE WORK
3. EMPTYING THE SMX HOPPER
Empty the hopper after work and before performing any type of maintenance, to do so proceed as follows:
1. Remove the hopper from the brush head and clean it thoroughly
2. Remove the hopper suction filter and clean it with a continuous jet of water
3. reassemble all the elements.
4. Raise the brushing unit at the end of the work, to avoid deforming the brushes.
WARNING: this operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
3. STORING OF THE MACHINE
Proceed as follows to store the machine at the end of work:
1. Place the machine in a place where it can not cause damage or injury
2. Position the machine where the accidental fall of objects do not cause damage
3. Engage the parking brake
4. Turn the key switch to the “0” position
5. Disconnect the machine connector
6. Lift the brush head and squeegee
To Next Page
Loading...
