FINE mechatronics FS-8000 - Page 8

---------------------------------------------------------------------------------
FINE MECHATRONICS FS8000
8
☞ PRINT Key : This Key is to Transmit,Totalize,Print a DATA
* Unavailable to work it while Auto Mode
* Please push
CLR + Print when deleting the last TOTAL date.
Only Unavailable to re-power,change the PART,Available 1time only
(The last total data will be deleted also on Auto-total)
☞ CLR Key : This have 4way to use as folllows .
1) When cancelling it with inputing the setting value
2)
CLR + TOTAL(+TOTAL) +SET When setting the total data.
3)
CLR + Print when deleting the last TOTAL date
4) When using SETUP or CALIBRATION ( 3Chapter, 4Chapter REFERENCE)
* After
CLR Key,If no a addtional data,it will be deleted automatically. .
☞ SET/CAL
Key : SET key have 2way to use as follows
1) When recording each setted data
2) When using SETUP or CALIBRATION( 3Chapter, 4Chapter REFERENCE)