411UD Document #50759 Rev. E 12/09/2008 P/N 50759:E 51
Programming Sheets
78
79
80
Input Channel 4 Delay Timer. Enter 0 - 179 seconds delay. Factory default is '000' for no
delay. Does not delay Input Channels programmed for fire functions.
81
Touchtone/Rotary Select for Primary Phone. Enter '0' for touchtone dialing; '1' for rotary dialing.
82
Make/Break Ratio for Primary Phone. Enter '0' for 67/33 ratio; '1' for 62/38 ratio.
83
Touchtone/Rotary Select for Secondary Phone. Enter '0' for touchtone dialing; '1' for rotary dialing.
84
Make/Break Ratio for Secondary Phone. Enter '0' for 67/33 ratio; '1' for 62/38 ratio.
85
Future Use.
86
Future Use.
87
Output Relay Enable. Enter '0' to disable relay; '1' to enable relay.
88
Output Relay Function Selection. Enter '0' for activation on fire alarm; '1' for host control panel trouble; '2' for
fire supervisory; '4' for AC loss; '6' for communication failure; '7' for DACT trouble.
89
Trouble Call Limit. Enter a '0' to disable this feature; '1' to enable Trouble Call Limit. Factory default is '0' for
disabled.
90
91
92
93
Future Use.
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
Addresses 94 to 113 store the Service Terminal 1 Phone Number. Valid entries are 0 - 9 and A - E. 'F'
designates the end of the phone number.
114
115
Ring Count on Primary Phone Line. Enter number of rings prior to panel answering call. Valid entries
are 00 to 25 (00 = no answer). Factory default is 03.
116
Future Use.
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
Addresses 117 to 136 store the Service Terminal 2 Phone Number. Valid entries are 0-9 and
A-E. 'F' designates the end of the phone number.
137
Upload/Download Backup Reporting. Enter '0' for Upload/Download reports to go to the Secondary Central
Station Phone Number on backup only; '1' for Upload/Download reports to always go to the Secondary; '2' for
Upload/Download reports to go to the first available Central Station phone number.
To Next Page
Loading...
