12 Fault Finding Guide Doc. version 2
2.6 COM1 Pseudo Points FIRECLASS Fire Alarm Control Panels
2.6 COM1 Pseudo Points
When reported on the user interface or via printers, the
output format used for faults reported from COM1 is:
‘COM1’
2.7 COM2 Pseudo Points
When reported on the user interface or via printers, the
output format used for faults reported from COM2 is:
‘COM2’
2.8 COM3 Pseudo Points
When reported on the user interface or via printers, the
output format used for faults reported from COM3 is:
‘COM3’
This section refers to a fault regarding the
presence or absence of a printer connected
to COM1
Point
Address
Label Use
1 Printer Comms If a printer is configured and is not connected to the panel, this monitor
point is activated.
Table 6: COM1 Pseudo Points
This section refers to faults regarding COM2
which is the configuration of the FIRECLASS
Remote port.
Point
Address
Label Use
1 Comms Fault Will report a fault if the packet retries exceed the maximum number (100).
Table 7: COM2 Pseudo Points
This section refers to faults regarding COM3
on the panel which is used to connect to the
network card.
Point
Address
Label Use
1 Comms Fault Will report a fault if the packet retries exceed the maximum number (100).
Table 8: COM3 Pseudo Points
To Next Page
Loading...
