FIRECLASS Fire Alarm Control Panels 2.9 Loop Pseudo Point
Fault Finding Guide Doc. version 2 13
2.9 Loop Pseudo Point
When a state is raised for the loop, not a point in the
loop then the address is simply the loop letter.
Pseudo
Point
Address
Label Use
1 Loop Status The point is used for the following information:
Loop shutdown
Loop open or short circuit
Unconfigured device, this point is used if the point is at
address 255, otherwise the point
address 1 to 250 is used.
Firmware Incompatible
Polling Error
To Next Page
Loading...
